Mirror silicone 310 ml.


The surface, which is to be applied silicone, should be clean and free of dust, dirt, oil, grease, rust and other substances that impair adhesion. Glass, glazed surfaces, wood must be degreased with alcohol, white spirit or other solvent. Rusty steel surfaces should be cleaned with a wire brush, oxidized metals (e.g. copper, lead) – sanded, and then secured against corrosion. Remove remnants of the old sealant before carrying out maintenance work.

It is recommended to perform an adhesion test on the surface before using the product. In case of mirrors from unknown manufacturer, an adhesive test should be carried out before gluing. The mirror should be secured in accordance with DIN EN 1036:2001 ‘Glass in building’. In case of lacobel tiles from an unknown manufacturer, an application test should be done before gluing to verify whether there is any change in color of the working surface of lacobel tiles.

Silicone does not require a primer, but on the specific surfaces there may be a need to use a primer. Prior to silicone application the rim should be secured with masking tape. Cut the tip of the cartridge, leaving part of the thread. Screw the applicator at the thread, cut at an angle adjusted to the width of the joint. Apply with a manual or pneumatic gun. The product should be applied in parallel, vertical strand or by point application to allow evaporation of curing silicone by-products. Do not seal the edges of mirror until the silicone is cured. Depending on the size and weight of the mirror, after gluing, it should remain supported by several hours.

Silicone can be smoothed with a spatula for silicone spreading that is dampened in a solution of soap. Use tools from plastic or stainless steel. Silicone is cured by reaction with moisture from the air, therefore, the seal should be performed under conditions that allow access of air.

Washing of cured sealant with commercially available cleaning agents prolongs the lifespan. After use, wipe the tools with a paper towel and clean with solvent.


H-silicone mirror is an one-component adhesive without solvents. It is colorless. It has excellent adhesion to most materials and surfaces common in the construction industry: glass, raw and painted wood, tile, brick, concrete, aerated concrete, cement, mortar, laminated glass, metal and most non-malleable plastics. Due to its excellent consistency and color, it allows the edges of mirrors to be sealed. The consistency and color also allow to seal the edges of mirrors.


  • mounting of decorative mirrors on different surfaces, e.g. glaze, glass, plaster,
    concrete, OSB, wood, plywood
  • bonding mosaic mirrors (mirror-mirror bonding) in shower cabins
  • mounting mirrors on surfaces exposed to vibration and stress (new construction)
  • mounting mirrors and bulky lacobel tiles (e.g. in building systems with sliding doors)
  • grouting edges of mirrors (after fully cured elements that were glued)
  • bonding mirrors in the metal, wood or plastic frames
  • mounting glass elements outdoors

Packaging and storage:

Store in original packaging in a dry and cool place for a period of 18 months from the production date at temperatures from 5 up to 35 °C. Protect from freezing temperatures and reach of children.